Vend side port map

Vend Side Quick Terminal

J9
DesignatorJ9
Existing coin and bill acceptor ports (terminal types)
Connector141R-2.54-8P
Pin #Pin NameAnnotation
1GNDBill acceptor - Pole Power (Input/Output)
2GNDBill acceptor - Pole Power (Input/Output)
312VBill acceptor + Pole Power (Input/Output)
4INHIBITBill acceptor Inhibit Deactivate Output Signal
5JAMBill acceptor 1P Coin Insertion Signal
6VENDBill acceptor 2P Coin Insertion Signal
7START1Start Button 1 Input Signal
8START2Start Button 2 Input Signal
  • Pins are counted from the left.
  • You can also input power directly into BillMock-HW through 12V and GND pins.
  • While it's more convenient to strip tde insulation from tde cable in tde middle and tden connect it to tde terminal,
  • It's recommended, whenever possible, to use a cable type that comes pre-equipped for the connection.
  • START1/2 can be changed to JAM based on DIP switch settings

Vend Side Player 1 Port (left)

J7
DesignatorJ7
Player 1 side existing
coin and bill acceptor port
ConnectorMolex 53014-10xx
HousingMolex 51004-10xx
CrimpMolex 50011
Pin #Pin NameAnnotation
1N/CNot Connected
2VENDBill acceptor Coin Insertion Signal
3N/CNot Connected
4STARTStart Button Input Signal
5INHIBITBill acceptor Inhibit (Deactivate) Output Signal
6GNDBill acceptor - Pole Power (Input/Output)
7N/CNot Connected
812VBill acceptor + Pole Power (Input/Output)
912VBill acceptor + Pole Power (Input/Output)
10GNDBill acceptor - Pole Power (Input/Output)
  • Pins are counted from the left.
  • START can be changed to JAM based on DIP switch settings

Vend Side Player 2 Port (right)

J8
DesignatorJ8
Player 2 side existing
coin and bill acceptor port
ConnectorMolex 53014-10xx
HousingMolex 51004-10xx
CrimpMolex 50011
Pin #Pin NameAnnotation
1N/CNot Connected
2VENDBill acceptor Coin Insertion Signal
3N/CNot Connected
4STARTStart Button Input Signal
5INHIBITBill acceptor Inhibit (Deactivate) Output Signal
6GNDBill acceptor - Pole Power (Input/Output)
7N/CNot Connected
812VBill acceptor + Pole Power (Input/Output)
912VBill acceptor + Pole Power (Input/Output)
10GNDBill acceptor - Pole Power (Input/Output)
  • Pins are counted from the left.
  • START can be changed to JAM based on DIP switch settings